It may seem like a walk in the park, but paving a good walkway is a challenging task. You will need to have a good plan and you will need to put in a lot of hard work. There are typically two methods that you can choose if you are planning on putting in a concrete path. The first method is to hire an expert to do it for you and then the second method is to do it yourself. You will also have a lot of options to choose from if you want to hire a professional to install the path for you. And if you want to install a concrete path on your own, there are some methods you may want to think about.
The first and most important thing before attempting any project is to ensure you are using the proper safety equipment for the job. Safety glasses, steel toed boots, gloves, and other gear is always vital when doing any kind of work to your landscape.
How to Install a Concrete Path
Installing your very own concrete path can be quite a difficult job, but it is not impossible. Before you begin doing any work, you will want to check with your city and see if you need a permit or not.
The first step to making the path is to plan out where the walkway will end up. Then spray paint it on your lawn to help you draw it out.
Once it has been completely mapped, you will want to dig it out about four or so inches deep.
When you dug out the path, make sure to inspect the soil. If the soil is sandy or soft, then it has to be toughened up. You can do this by putting in clay or gravel.
To make sure that your walkway is the size you want it, frame it out using some two by fours.
To make the concrete path stronger, you will want to put some reinforcing steel into it.
Before you put in the cement, you will want to plan out how you will pour it out. It is important that you level out the path and make sure it is totally flat. Also, when the concrete is poured you will want to run a broom over the cement, this will give the cement texture so people will have some extra grip when they are using the walkway.
When you poured out the cement, it is important to cut some control joints every four or five feet depending on your path. In order to do this, you will need to use a groover.
Once the concrete has been laid, then the next step is to let it cure and wait. You can cure the concrete by using chemicals or using a layer of plastic sheet. This will make sure that the concrete can cure properly and will not dry too fast.
And within a few short days, you will be able to enjoy your brand new concrete path.